Not too small, not too big, this 3D bear mould is just right!
The assembly of this bear mould requires cutting down the lines between the two halves which can then be pressed together and a filling hole created in the base. Secure with extra bulldog clips around the edges and placed in a bowl for support and it is able to be filled. Allow to set before carefully unmoulding. If the bear is not unmoulding successfully, place in refrigerator for a short amount of time and then try again.
Clean up seam marks with the back of a butter knife and it will be ready to go.

These moulds are a thinner plastic than some and do not tolerate temperatures over 60ºC well so advise you soap cooler with this one.

Capacity: 60gm

Length: 40mm
Width: 35mm
Height: 90mm

2 cavities (4 halves)

Availability: 4 In Stock